Def Mod Manuals

DNA Manual - 

This is a short down and dirty run down on your new DNA mod. The number one thing is never drain your mod to 0% and leave it. Your new mod has idle draw so it will normally draw 4-5% battery life per day sitting idle. Another key thing is if you have a lipo mod try and never let it go below 20%. The reason being is constantly draining under 20% will degrade your lipo faster and make its lifespan shorter. So instead of a lipo that lasts 5-6 years it will last 4-5 years.  When you plug your mod in to charge, do not use it. Picking it up and setting it down over and over while cord is plugged in will cause the USB port to wear faster. The cord in short rubs the pads back and forth and grinds away the metal. 

For all the details for your new DNA please visit this website. Theres tons of features in your DNA and Evolv (maker) has very detailed manuals that explain things far better then my dumbass can :) 

https://downloads.evolvapor.com

 

PWM Manual -

The single biggest most important thing with a PWM mod is to NEVER work your coils out on it. PWMs do not have safeties on them and when you work out coils the ohms will have drastic bouncing. So for argument sake you put a .25 ohm coil setup on it and start glowing your coils to work out hot spots, those ohms can jump all the way down to a 0.05 instantly and this ohm value will blow the mosfet(absorbs the current) on your PWM and you will have to send it in for a board replacement.  

On our def rocket which is 8.4v never go under .15 ohms. If you to decide to go all the way to 0.15 you MUST let the mod rest for 3-4 mins between puffs to allow the mosfet and batteries to cool. Do not chain vape at 0.15. You can go down to .20 and chain vape all you want

On out LIPO def mod PWM do not go under .20 ohms. Again like above if you decide to go to .20 you need to let the mod sit between puffs to allow the hardware to cool. Think of it as a dragster. They go hard for 2 seconds then then sit a while.